Product Details  SOLVENT RECOVERY UNIT @flexo 30L-RHB SPECIAL FEATURES Solvent recovery unit  SOLVENT RECOVERY UNIT @flexo 30L-RHB  @flexo 60L-RHB @flexo 80L-RHB SPECIAL FEATURES Solvent recovery unit For photopolymer flexo plates A. General description:  @80L-RHis designed for recovery of flexographic photopolymer plate solventwashout chemical and any environmental green chemical with specialtiesof distilling and cooling, can be connected with in-line processor andany plate washout machine directly. With cold air circulation and drainout of residue for high speed recovery. Super recovering rate in theshortest time, is an ideal and high efficient recovery unit forflexographer.  B. Technical information:  Recovery volume 60 / 80 liters Power consume 220V 4. 65kw Diathermic oil 23 KG Machine dimension 1100x 780x1200 mm Main body Recovery rate 85%  C. Operating steps:  After opening the crate, plug in 220 V power, and connect the ground (earth) .  Open Open the lid and fill the tank up to the level with solvent to be recovered (80 L)  Close the lid and tighten it.  Check all the pipe / hose make sure it is well connected. Especially vacuum pipe (6) and fresh come-out pipe (1) .  Set up the thermostat (18) for example for Perc. Is 150 degree C, for green chemical is 160-210 degree C. Vacuum tank pressure (3) high at 0. 03 Mpa / low at 0. 01mpa, and steam cooling fan thermostat (11) at 40 degree C. Turn on the power switch (15) , steam cooling switch (16) , heater switch (17) and vacuum pump switch (12) .  Ifyou want to be controlled with timer, it depends on the quantity of thechemical, set up the timer (14) then turn on the switch (13) .  D. Important:  Install the unit in a wide and ventilated place.  Disconnect electric power before doing any action.  No taking off the control panel Change the diathermic oil every 1000 working hours.  No filling the solvent container up over the level (80 liters)  Remove the waste after every recovery process